Abstract: The steam generator tube rupture (SGTR) accident is one of the design basis accidents of lead-cooled fast reactor (LFR). In the event of such an accident, a subcooled water jet is generated in the lead pool of primary circuit, which forms a complicated distribution of the liquid metal-gas two-phase flow. The detection of the two-phase interface and migration of steam bubbles is an significant part of reactor safety analysis. Due to the opacity, corrosiveness, high temperature of liquid metal, and the current limitations of measurement methods involving liquid metal-gas two-phase flow, a diamond-like carbon (DLC) coated wire-mesh sensor (WMS) based on electrical principles was proposed in this paper. The sensor could achieve the image of the liquid metal-gas two-phase distribution inside the flow channel, while preventing the corrosion failure of the sensor. Based on the COMSOL software, a numerical model of the DLC coated WMS was established. Selecting the materials of two phases as liquid GaInSn alloy and air, the simulation of the electric field in the liquid metal environment containing a single bubble was performed, and an electric signal value matrix representing the liquid metal-gas two-phase was output. The signal matrix was further normalized through the linear relation to obtain the two-phase distribution image, which verified the application feasibility of the coated WMS in liquid metal. In addition, a prototype of the DLC coated WMS was manufactured, and the numerical simulation results were experimentally validated in order to demonstrate the rationality of the numerical model. Furthermore, the influence of different structural parameters on the measurement accuracy of coated WMS was studied in detail by changing the transverse interval, axial interval, electrode diameter, coat thickness, and the size of air bubble. The simulation results show that the electric field distribution in the liquid metal-gas two-phase environment differs significantly from that in conventional fluid medias such as water-gas due to the high relative permittivity of liquid metal. On the other hand, considering the resolution of the WMS and the phenomenon of electric signal crosstalk, the transverse interval of electrode should be selected between 2-3 mm, and the axial interval should be selected between 1.5-2 mm to achieve high measurement accuracy. The coat thickness and electrode diameter have little influence on the measurement accuracy, but to reduce the intrusion effect of the WMS, the electrode diameter should be selected between 0.4-0.5 mm and the coat thickness should not exceed half of the electrode radius. This study could guide the practical application of DLC coated WMS in the liquid metal-gas two-phase environment and provide a technical basis for the analysis of multi-phase distribution under SGTR accidents.