185, 187Re (n, 2n)反应激发函数评价

Evaluation of Excitation Functions for 185,187Re (n, 2n) Reaction

  • 摘要: 185Re(n, 2n)184Re与187Re(n, 2n)186Re反应截面数据是聚变堆活化分析、中子诊断与医用同位素生产的关键核数据,然而现有实验测量分歧显著、各评价库推荐值趋势分化,且部分评价数值直接参考原始实验数据,缺乏实验物理层面的系统甄别。为给出可靠的截面推荐值,系统收集了20 MeV以下能区上述两个反应道的实验数据,从样品制备、γ能谱测量及所用核参数(监测截面、衰变分支比、半衰期)等方面对实验数据开展修正与筛选,使多数处理后的实验数据在误差范围内符合良好。进而采用TALYS-2.2核反应理论计算程序,在TENDL-2023评价库参数基础上适当优化,完成两个反应的激发函数评价。结果表明,推荐值与筛选后实验数据一致,高能区下降趋势较部分评价库更合理,可为聚变堆中子学及核数据库更新提供可靠数据支撑。

     

    Abstract: Rhenium is a refractory metal with high resistance to heat and corrosion, and rhenium-containing materials are relevant to nuclear technology. Natural rhenium consists of two naturally occurring isotopes, 185Re and 187Re, with abundances of 37.40% and 62.60%, respectively. In deuterium-tritium fusion systems, 14 MeV neutrons activate rhenium-containing structural materials and induce the 185Re(n, 2n)184Re and 187Re(n, 2n)186Re reactions. Reliable cross sections for these reactions are basic nuclear data for activation analysis in fusion reactors, fusion neutron diagnostics, radioactive waste management, and the production research of the medical radionuclide 186Re. However, the available measurements show large discrepancies, and differences of more than 40% occur among some experimental results. The main sources of disagreement are differences in sample preparation, inconsistent monitor cross sections and decay data, and limitations in gamma-ray spectrometric activity measurements. The 185Re(n, 2n)184Re reaction is especially difficult to measure because 184Rem feeds 184Reg through isomeric transition, several characteristic gamma rays overlap or interfere with each other, and low-energy gamma rays are strongly affected by self-absorption in rhenium samples. In addition, many existing evaluations fit nuclear-reaction calculations directly to raw experimental data, without first screening the measurements from an experimental physics standpoint. As a result, the recommended values in different evaluated nuclear data libraries still diverge. The experimental data for the two reactions below 20 MeV and provides recommended excitation functions was evaluated. Experimental datasets were collected from the EXFOR library. Twelve datasets were obtained for 185Re(n, 2n)184Re, eight datasets for 187Re(n, 2n)186Reg, and two datasets for 187Re(n, 2n)186Rem. In the activation formula, most input quantities, including the number of target nuclei, gamma-ray count rate, detector efficiency, monitor cross section, and gamma-ray branching ratio, scale linearly with the derived cross section. The decay constant is different because it enters through the irradiation-cooling-counting factor and affects the result nonlinearly. Therefore, the original data were checked under a unified parameter basis before comparison. Monitor cross sections were renormalized to the International Reactor Dosimetry and Fusion File (IRDFF-Ⅱ), and decay branching ratios were corrected to the NuDat 3.0 values when the original values were available. The datasets were then screened from three aspects: sample preparation, gamma-ray spectrometric measurements, and adopted nuclear parameters. Data were excluded when they involved inaccurate sample quantification, missing self-absorption corrections, unresolved ground-state and isomeric-state contributions, gamma-ray interference, internal inconsistency, unreliable monitor reactions, or half-life values that differed substantially from current recommended values. For 185Re(n, 2n)184Re, eight unreliable datasets were excluded. For 187Re(n, 2n)186Re, three datasets were excluded, while five 186Reg datasets and two corrected 186Rem datasets were retained. The excitation functions below 20 MeV were calculated with the TALYS-2.2 nuclear reaction code. The calculation used the TALYS-based Evaluated Nuclear Data Library (TENDL-2023) input parameters as the starting point. Most model settings, including the optical model parameters, the level density model, and the gamma-ray strength function were retained, and the spin cutoff adjustment was optimized. For 184Re, the spin cutoff adjustment increases from 0.2 to 0.6. For 186Re, it is increased from 0.1 to 0.2 to better describe the population of the high-spin isomeric state. The processed experimental data agree well within their uncertainties in the overlapping energy regions. For 185Re(n, 2n)184Re, the recommended values are close to JENDL-5. Above 16 MeV, the decreasing trend agrees better with the screened data than ENDF/B-Ⅷ.1, whereas JEFF-3.3 is systematically low. For 187Re(n, 2n)186Reg, the recommended values agree with the five retained datasets and are slightly lower than JENDL-5. In the high-energy region, only the present values and JENDL-5 remain consistent with the measurements within the reported uncertainties. For 187Re(n, 2n)186Rem, the recommended values are close to the two available experimental points, whereas JEFF-3.3 and TENDL-2023 are clearly low. For the total 187Re(n, 2n)186Re cross section, only library-to-library comparison is possible because no experiment has measured the ground-state and isomeric-state cross sections simultaneously. The present values are consistent with most libraries before the peak region. Overall, this work provides evaluated and recommended cross sections for the 185Re(n, 2n)184Re and 187Re(n, 2n)186Re reactions below 20 MeV. Screening the measurements from an experimental physics standpoint improves the consistency of the retained data and reduces part of the discrepancy inherited from the raw measurements. The recommended excitation functions provide a reference for evaluated nuclear data libraries and support fusion reactor neutronics analysis, radioactive waste management, and 186Re production research. Current measurements are still concentrated mainly in the 13-15 MeV region, and data above 15 MeV remain scarce. High-precision measurements at higher neutron energies are therefore needed to further constrain the excitation functions.

     

/

返回文章
返回